Inventor Customization

Inventor Customization

Reply
Active Member
7 Posts
0 Kudos
Registered: ‎04-03-2011
Post 1 of 3
Accepted Solution

Problem with Project Falcon ad-in in Inventor 2013

243 Views, 2 Replies
12-12-2012 09:11 PM

Just downloaded and Installed Project Falcon on my Inventor 2013 (64 bit) educational. Although I enable the ad-in in Inventor and using ad in manager from start menu, I am unable to use it to run simulations. 

 

What can I do?

Hi bijibijmak,

 

You might get a better response here:

Autodesk Discussion Groups > Autodesk Labs  > Project Falcon

http://forums.autodesk.com/t5/Project-Falcon/bd-p/Falcon

 

Maybe the moderators can move this topic to that forum to help others in the future.

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com

Valued Contributor
150 Posts
508 Kudos
Registered: ‎11-16-2007
Post 2 of 3

Re: Problem with Project Falcon ad-in in Inventor 2013

12-13-2012 03:41 AM in reply to: bijibijmak

I get a similar thing, if I have no geomtery in my model I can enter the Falcon environment, however, if any geometry exists Falcon will crash inventor.

*Expert Elite*
3,002 Posts
1,702 Kudos
Registered: ‎03-08-2006
Post 3 of 3

Re: Problem with Project Falcon ad-in in Inventor 2013

12-13-2012 07:59 AM in reply to: MattH_Work

Hi bijibijmak,

 

You might get a better response here:

Autodesk Discussion Groups > Autodesk Labs  > Project Falcon

http://forums.autodesk.com/t5/Project-Falcon/bd-p/Falcon

 

Maybe the moderators can move this topic to that forum to help others in the future.

 

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com



  solution.png  Did you find this reply helpful ? If so please use the Accept as Solution or  Kudos button below.





Post to the Community

Have questions about Autodesk products? Ask the community.

New Post