Ilogic to fill category in iproperties based on conditions

[Anonymous]

Hi all,

I want to fill the Summary >  category tab in iproperties of the parts of an assembly based on a certain logic.

If the part is sheet metal only 

then enter "LC + thickness mm" in the category tab of that part.

If the part is sheet metal and has bending only 

then enter "LC + thickness mm + BEND" in the category tab of that part.

If the part is sheet metal and has tapped holes only 

then enter "LC + thickness mm + TAP" in the category tab of that part.

Thanks for your help.

Sid,

Using inventor 2011

[RodrigoEiras]

Hi Sid,

I think there are already some posts that can easily help you to do that. I think the most important one you need is:

http://forums.autodesk.com/t5/inventor-customization/find-sheet-metal-thickness-with-vb-net/m-p/3672...

http://forums.autodesk.com/t5/inventor-customization/ilogic-code-to-update-sheet-metal-thickness-par...

http://forums.autodesk.com/t5/inventor-general-discussion/how-to-use-parameters-in-the-iproperties-f...

I hope this helps.