Inventor Customization

Inventor Customization

Reply
Active Member
aaronlewer
Posts: 8
Registered: ‎03-04-2010
Message 1 of 3 (236 Views)

DrawingView.Center vs. DrawingView.Position

236 Views, 2 Replies
10-08-2010 12:46 PM
From the helpfile: DrawingView.Center "Gets and sets the display center point of the drawing view on the owning sheet." DrawingView.Position "Gets and sets the point used to position the drawing view on the sheet." Could anyone explain the difference between these properties? Both properties seem to behave identically.
Board Manager
sanjay.ramaswamy
Posts: 110
Registered: ‎11-13-2007
Message 2 of 3 (233 Views)

Re: DrawingView.Center vs. DrawingView.Position

10-08-2010 04:52 PM in reply to: aaronlewer

The Center property returns the center of the view for all view types. The Position property (which specifies the point used to place/position the view) happens to be the view center for most view types except draft views. For draft views, the position property returns the lower left corner of the view.

 

Active Member
aaronlewer
Posts: 8
Registered: ‎03-04-2010
Message 3 of 3 (215 Views)

Re: DrawingView.Center vs. DrawingView.Position

10-11-2010 07:15 AM in reply to: sanjay.ramaswamy
Thanks!
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.