Installation & Licensing

Installation & Licensing

Reply
Valued Contributor
91 Posts
22 Kudos
Registered: ‎10-28-2007
Post 11 of 13

Re: Unable to install Autodesk Design Review 2012

08-30-2013 07:35 AM in reply to: toddw.schuler

Before the Design Review 2012 installer starts the installation the "install conditions" were checked. What you can do is add the required keys to the registry so that the installer thinks the runtimes were installed.

 

8-30-2013 4-31-47 PM.png

 

You can create a .reg file to add the necesarry entries.

 

Remember that the ADR installer is a 32-bit installer, so all entries are for 32-bit.

 

Markus

Active Contributor
32 Posts
6 Kudos
Registered: ‎11-13-2006
Post 12 of 13

Re: Unable to install Autodesk Design Review 2012

08-30-2013 07:41 AM in reply to: toddw.schuler
Thanks, that sounds like a good option, what is the best way to determine the required keys?


Todd S.
Design and Drafting Supervisor
Energizer Battery Manufacturing
Phone 440-835-7876




________________________________

This email and any files transmitted with it are confidential and intended solely for the use of the individual or entity to whom they are addressed. If you are not the named addressee you should not disseminate, distribute, retain, or copy this e-mail or any attachments. If you have received this email in error please delete and notify the sender.
Valued Contributor
91 Posts
22 Kudos
Registered: ‎10-28-2007
Post 13 of 13

Re: Unable to install Autodesk Design Review 2012

08-30-2013 09:30 AM in reply to: toddw.schuler

If you try to install with setup.exe you see in the log files which VC runtime fails. And if you are sure, that you have i.e. a higher VC2008 runtime installed, then you can temporarily add one of the keys to the registry.

 

Then this check during the installation process is TRUE

 

On the screen shot the right column says for which runtime the regkey is.

 

You can send me your install log file from the %temp% folder, than I can take a look.

 

regards

 

Markus

 

 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post