Installation & Licensing

Installation & Licensing

Reply
*Wheeler, Robert
Message 1 of 2 (115 Views)

Running Softdesk R12 under Windows NT?

115 Views, 1 Replies
01-28-2000 01:33 PM
I am trying to install Acad R12 and Softdesk R12 on a Windows NT
Workstation. Acad runs ok but I get a "divide by zero or overload
error" message when Softdesk attempts to initialize when starting a
new drawing. The following command sequence is received:

Initializing adcadd civil environment
Load application cogo
Unable to execute "\adcadd\civil\cogo\exe\cogo"
Error xload failed
Divide by zero or overload error

Is there a fix for this problem?
Can Softdesk 12 run under Windows NT?

Bob Wheeler
*Schroeder, Bud
Message 2 of 2 (115 Views)

Re: Running Softdesk R12 under Windows NT?

01-28-2000 01:35 PM in reply to: *Wheeler, Robert
Hi Bob,

Even R12 is not running well on your NT box. Go take a look at CPU
processes while it is running. You will see it's pegged at 100%.
There was no NT 4x when these programs were written, just Windows 3x.

Hope this helps.

Bud

Robert Wheeler wrote:

> I am trying to install Acad R12 and Softdesk R12 on a Windows NT
> Workstation. Acad runs ok but I get a "divide by zero or overload
> error" message when Softdesk attempts to initialize when starting a
> new drawing. The following command sequence is received:
>
> Initializing adcadd civil environment
> Load application cogo
> Unable to execute "\adcadd\civil\cogo\exe\cogo"
> Error xload failed
> Divide by zero or overload error
>
> Is there a fix for this problem?
> Can Softdesk 12 run under Windows NT?
>
> Bob Wheeler
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.