Installation & Licensing

Installation & Licensing

Reply
Active Member
warobertson
Posts: 6
Registered: ‎06-23-2006
Message 1 of 2 (846 Views)
Accepted Solution

Network Licence To Standalone Licence Transfer

846 Views, 1 Replies
12-03-2012 09:14 AM

Hi,

 

We have a network license of AutoCAD 2013 installed on a couple of machines, due to the conflict in a standalone install of Fabrication CADmep 2013 we need to move the AutoCAD 2013 license from Network to Standalone. We have the standalone license number and product codes. We just need to understand if we have to uninstall the network autoCAD and re install or is it possible to assign the standalone license number to the current install.

 

Regards

 

WillieR

 

*Expert Elite*
TravisNave
Posts: 10,146
Registered: ‎01-14-2005
Message 2 of 2 (837 Views)

Re: Network Licence To Standalone Licence Transfer

12-03-2012 01:59 PM in reply to: warobertson

Nope, you will have to reinstall as stand-alone so that it properly licenses.  You can try the reg hack but it'll probably cause more trouble than it is worth.  A clean reinstall will get you where you need to be.

Travis Nave Send TravisNave a Private Message                       Need help in your post? Mention me with @TravisNave
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.