Installation & Licensing

Installation & Licensing

Reply
Active Member
warobertson
Posts: 6
Registered: ‎06-23-2006
Message 1 of 2 (928 Views)
Accepted Solution

Network Licence To Standalone Licence Transfer

928 Views, 1 Replies
12-03-2012 09:14 AM

Hi,

 

We have a network license of AutoCAD 2013 installed on a couple of machines, due to the conflict in a standalone install of Fabrication CADmep 2013 we need to move the AutoCAD 2013 license from Network to Standalone. We have the standalone license number and product codes. We just need to understand if we have to uninstall the network autoCAD and re install or is it possible to assign the standalone license number to the current install.

 

Regards

 

WillieR

 

Nope, you will have to reinstall as stand-alone so that it properly licenses.  You can try the reg hack but it'll probably cause more trouble than it is worth.  A clean reinstall will get you where you need to be.

*Expert Elite*
TravisNave
Posts: 10,617
Registered: ‎01-14-2005
Message 2 of 2 (919 Views)

Re: Network Licence To Standalone Licence Transfer

12-03-2012 01:59 PM in reply to: warobertson

Nope, you will have to reinstall as stand-alone so that it properly licenses.  You can try the reg hack but it'll probably cause more trouble than it is worth.  A clean reinstall will get you where you need to be.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!