Installation & Licensing

Installation & Licensing

Reply
Active Member
warobertson
Posts: 6
Registered: ‎06-23-2006
Message 1 of 2 (909 Views)
Accepted Solution

Network Licence To Standalone Licence Transfer

909 Views, 1 Replies
12-03-2012 09:14 AM

Hi,

 

We have a network license of AutoCAD 2013 installed on a couple of machines, due to the conflict in a standalone install of Fabrication CADmep 2013 we need to move the AutoCAD 2013 license from Network to Standalone. We have the standalone license number and product codes. We just need to understand if we have to uninstall the network autoCAD and re install or is it possible to assign the standalone license number to the current install.

 

Regards

 

WillieR

 

Nope, you will have to reinstall as stand-alone so that it properly licenses.  You can try the reg hack but it'll probably cause more trouble than it is worth.  A clean reinstall will get you where you need to be.

*Expert Elite*
TravisNave
Posts: 10,501
Registered: ‎01-14-2005
Message 2 of 2 (900 Views)

Re: Network Licence To Standalone Licence Transfer

12-03-2012 01:59 PM in reply to: warobertson

Nope, you will have to reinstall as stand-alone so that it properly licenses.  You can try the reg hack but it'll probably cause more trouble than it is worth.  A clean reinstall will get you where you need to be.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.