Installation & Licensing

Installation & Licensing

Distinguished Contributor
Posts: 165
Registered: ‎01-26-2004
Message 1 of 2 (424 Views)
Accepted Solution

Multipel Error 1406 errors trying to install Inventor

424 Views, 1 Replies
12-23-2012 09:38 AM

During re-installation of Inventor 10 I get many errors 1406 not being able to write to e.g. \EnableFullPage\.swf and many others. This is the first time i have gotten this and I am at a loss. I have tried to change permissions in the Registry, but I am getting nowhere. Does irt have perhaps to do with the fact that I am installing on drive F:\ and not C:\ (not enough room - small solid state) 

*Expert Elite*
Posts: 10,146
Registered: ‎01-14-2005
Message 2 of 2 (384 Views)

Re: Multipel Error 1406 errors trying to install Inventor

12-26-2012 11:11 AM in reply to: dknaggert

That's an old *known* error back in the day for Macromedia Flash player.  You can safely hit IGNORE on about a dozen of those error messages and your Inventor will install.  Then I would recommend that you go to and update your Flash player to the latest version.  You should be good to go.


Travis Nave Send TravisNave a Private Message                       Need help in your post? Mention me with @TravisNave
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.