Installation & Licensing

Installation & Licensing

Reply
New Member
jcushing.cc
Posts: 1
Registered: ‎10-28-2012
Message 1 of 3 (287 Views)

Moving C drive files

287 Views, 2 Replies
10-28-2012 04:29 PM

Hello,

 

I just installed Revit Arch. 2013 on a drive other than C. My C drive is nearing capacity and I would like to make some more space. It still installed files in my C drive under ProgramData\Autodesk that include subfolders shown in the attached picture. Is it possible to move these over to another drive?

Employee
DannyHubbard
Posts: 327
Registered: ‎05-17-2007
Message 2 of 3 (271 Views)

Re: Moving C drive files

10-29-2012 05:03 AM in reply to: jcushing.cc

Check out the following post, should help you out.

http://forums.autodesk.com/t5/Installation-Licensing/Can-t-Install-on-a-non-bootable-Hard-drive/m-p/...

 

Thanks,

Danny



Danny Hubbard
QA Analyst
Autodesk, Inc.
*Expert Elite*
TravisNave
Posts: 10,747
Registered: ‎01-14-2005
Message 3 of 3 (248 Views)

Re: Moving C drive files

10-30-2012 07:00 AM in reply to: jcushing.cc

You can probably free a lot of space on C:\ by moving your %TEMP% location, your paging swap file, and disabling your hibernation file.  I suspect that would free up close to 10GB of space alone.  Reducing your browser cache along with some other basic cleanup can free up tons of space. 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.