Installation & Licensing

Installation & Licensing

Reply
New Member
jcushing.cc
Posts: 1
Registered: ‎10-28-2012
Message 1 of 3 (262 Views)

Moving C drive files

262 Views, 2 Replies
10-28-2012 04:29 PM

Hello,

 

I just installed Revit Arch. 2013 on a drive other than C. My C drive is nearing capacity and I would like to make some more space. It still installed files in my C drive under ProgramData\Autodesk that include subfolders shown in the attached picture. Is it possible to move these over to another drive?

Employee
DannyHubbard
Posts: 268
Registered: ‎05-17-2007
Message 2 of 3 (246 Views)

Re: Moving C drive files

10-29-2012 05:03 AM in reply to: jcushing.cc

Check out the following post, should help you out.

http://forums.autodesk.com/t5/Installation-Licensing/Can-t-Install-on-a-non-bootable-Hard-drive/m-p/...

 

Thanks,

Danny



Danny Hubbard
QA Analyst
Autodesk, Inc.
*Expert Elite*
TravisNave
Posts: 10,146
Registered: ‎01-14-2005
Message 3 of 3 (223 Views)

Re: Moving C drive files

10-30-2012 07:00 AM in reply to: jcushing.cc

You can probably free a lot of space on C:\ by moving your %TEMP% location, your paging swap file, and disabling your hibernation file.  I suspect that would free up close to 10GB of space alone.  Reducing your browser cache along with some other basic cleanup can free up tons of space. 

Travis Nave Send TravisNave a Private Message                       Need help in your post? Mention me with @TravisNave
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.