Installation & Licensing

Installation & Licensing

Reply
New Member
rob.cooper
Posts: 1
Registered: ‎05-12-2009
Message 1 of 2 (98 Views)

Mistake installing a network licence as a stand alone

98 Views, 1 Replies
12-03-2012 06:54 AM

Hi

 

I'm not much of an expert when it comes to software installation however here's what i've done wrong:

 

I installed the my new 'Building Designer Suite Ultimate 2013' as a stand alone licence. Then found out that the software purchased is intended for a network licence.

 

So i've Ran through the LMTOOLS utility as per the tutorial and the licence is working correctly (Aparently) but because i've installed the product as a stand alone licence what is the easyest way to get the software to notice the network licence. Obviously i don't want to spent 3 hours re-installing it again.

 

Any suggestions would help.

*Expert Elite*
DarrenP
Posts: 7,230
Registered: ‎09-13-2007
Message 2 of 2 (91 Views)

Re: Mistake installing a network licence as a stand alone

12-03-2012 08:18 AM in reply to: rob.cooper

rob.cooper wrote:

 Obviously i don't want to spent 3 hours re-installing it again.

 

 


your going to have to

you have to uninstall everything and reinstall as a network

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.