Installation & Licensing

Installation & Licensing

Active Member
Posts: 6
Registered: ‎10-15-2012
Message 1 of 1 (358 Views)

DWG TrueView 2013 won't run the second time

358 Views, 0 Replies
10-18-2012 10:06 AM
DWG TrueView 2013 Cannot Open the Second Time


Since it may relate to installation, I post it for any resolution.


before I remove my older version of TrueView, I installed TrueView 2013-32bit on an XP with all .Net 4 and it worked fine the first time I opened. The next day I open TrueView 2013 it has the following message:

Unable to run DWG TrueView. This may be due to one of the following:

1) This version of DWG Trueview was not installed properly. In this case, you may wish to reinstall DWG TrueView.

2) You do not have sufficient rights to run DWG TrueView.

Wherever I open a DWG files, it gives me the following message:


Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.