Installation & Licensing

Installation & Licensing

Reply
New Member
dtsc1
Posts: 2
Registered: ‎02-04-2013
Message 1 of 3 (245 Views)
Accepted Solution

Autodesk Inventor Fusion installation Failure

245 Views, 2 Replies
02-04-2013 08:09 AM

I have been tasked with installing Autodesk on one computer in our network (It is a Network installation). I have installed some Autodesk (2012) products on the PC; however I am experiencing a problem with Autodesk Fusion. The installation terminates successfully, however when I double click on the icon to run it, the application starts and shortly produces an error message. A screen shot of the error is attached. Could you please advise?

Thank you very much for the advice. The PC did not have the right driver!

*Expert Elite*
DarrenP
Posts: 7,671
Registered: ‎09-13-2007
Message 2 of 3 (241 Views)

Re: Autodesk Inventor Fusion installation Failure

02-04-2013 08:25 AM in reply to: dtsc1

it tells you what the problem is

its your graphics card or the driver

New Member
dtsc1
Posts: 2
Registered: ‎02-04-2013
Message 3 of 3 (235 Views)

Re: Autodesk Inventor Fusion installation Failure

02-04-2013 09:17 AM in reply to: DarrenP

Thank you very much for the advice. The PC did not have the right driver!

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.