Installation & Licensing

Installation & Licensing

Reply
New Member
dtsc1
Posts: 2
Registered: ‎02-04-2013
Message 1 of 3 (238 Views)
Accepted Solution

Autodesk Inventor Fusion installation Failure

238 Views, 2 Replies
02-04-2013 08:09 AM

I have been tasked with installing Autodesk on one computer in our network (It is a Network installation). I have installed some Autodesk (2012) products on the PC; however I am experiencing a problem with Autodesk Fusion. The installation terminates successfully, however when I double click on the icon to run it, the application starts and shortly produces an error message. A screen shot of the error is attached. Could you please advise?

Thank you very much for the advice. The PC did not have the right driver!

*Expert Elite*
DarrenP
Posts: 7,319
Registered: ‎09-13-2007
Message 2 of 3 (234 Views)

Re: Autodesk Inventor Fusion installation Failure

02-04-2013 08:25 AM in reply to: dtsc1

it tells you what the problem is

its your graphics card or the driver

New Member
dtsc1
Posts: 2
Registered: ‎02-04-2013
Message 3 of 3 (228 Views)

Re: Autodesk Inventor Fusion installation Failure

02-04-2013 09:17 AM in reply to: DarrenP

Thank you very much for the advice. The PC did not have the right driver!

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.