After installing AutoCAD 2013, along with Inventor Fusion and Design Review, I cannot load the software. The first time I installed it, it was able to run, with the screen opening, indicating if I wanted to try it or activate it, along with an error report message, which I send the report or close. After restarting, I now only get the error report message. As for Inventor Fusion and Design Review, as it is about to begin loading, it crashes. I uninstalled the program after a few trial and error sessions and the problem still remains. I have downloaded the software for my operating system.
Do I have to remove registry information to start the installation from scratch? If so, can anyone direct me to the exact location in the registry, as I do not want to delete vital data.
I know that report details from the error report form will give you more information as to what may be causing the issue, but if anyone can assist me without it, through their own experience or expertise, please do so, as I would rather not attempt to install it again.
16GB DDR3 RAM
1TB 7200RPM HD
Windows 7 (64 Bit) Ultimate Edition
AVG Internet Security Business Edition 2012 (Added the exception on firewall)
Same issue here ( Student license )
Toshiba Satellite L755
Intel Core i3-2330M CPU @2.20GHz
4gb RAM DDR3
Windows 7 Home Premium 64-bit OS
Intel HD Graphics with 64 MB - 1696 MB dynamically allocated shared memory
640GB 5400RPM Hard Drive
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!