Installation & Licensing

Installation & Licensing

Reply
Valued Contributor
dcorkill
Posts: 57
Registered: ‎01-29-2003
Message 1 of 3 (598 Views)

Autocad 2013 Deployment Issue

598 Views, 2 Replies
12-07-2012 07:51 AM

I've gone through the process of setting up the deployment.  During this process I unselected the inventor fusion add-on.  Now the problem I'm having when trying to run the deployment package to install autocad is that it's looking for the InventorFusion.msi file.  Seeing that I specifically unselected it why would it still be showing up and erroring out my deployment.

 

Any help would be greatly appreciated.

 

Thanks


Dylan

Product Support
jingy
Posts: 225
Registered: ‎10-14-2007
Message 2 of 3 (570 Views)

Re: Autocad 2013 Deployment Issue

12-09-2012 06:32 PM in reply to: dcorkill

Could you modify the deployment to check that is there any some special settings for the Inventor Fusion installation?

 

On the other side, you could edite the setup.ini file to add "#" in front of the line to check Inventor Fusion installation, then ignore the inventor the installation to check Inventor fusion.



Yong Jing
Product Support Specialist
Frontline Technical Support, CSS. GCSO
Valued Contributor
dcorkill
Posts: 57
Registered: ‎01-29-2003
Message 3 of 3 (550 Views)

Re: Autocad 2013 Deployment Issue

12-10-2012 08:58 AM in reply to: jingy

When I tried to go back in and modify the deployment it would error out again because the fusion files were missing. 

 

So i did a bit of other digging and then found that the entire fusion folder is missing from the deployment so I went into my folder that has all the installation files that I created the deployment from and copied over the fusion folder manually (not a good fix).  After doing this things seemed to progress better but now it errors out with a 1603.  I've attached the 2 log files that are created during install incase those help.

 

Just a bit of other background info.  I actually tried to create the deployment without installing inventor and I still got errors about inventor  

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.