Installation & Licensing

Installation & Licensing

Reply
Active Contributor
kzornoza
Posts: 31
Registered: ‎06-21-2007
Message 1 of 2 (158 Views)

AM2011 64 activation

158 Views, 1 Replies
07-07-2011 04:18 AM

Hi,

 

I've installed an AM2011 on a W7 64 in a trial mode with a 000 serial number. When I'm going to activate with a serial number, an error it showed. Moreover, the request code doesn't show in the register page. What is the problem? I have 15 days trial only.

 

Regards.

*Expert Elite*
TravisNave
Posts: 10,439
Registered: ‎01-14-2005
Message 2 of 2 (143 Views)

Re: AM2011 64 activation

07-07-2011 10:23 AM in reply to: kzornoza

The serial number you are using is not valid.  This is likely due to the fact that either the Subscription on the product has expired and/or the product has been upgraded or crossgraded to another version.

 

You need to contact your Reseller. 

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.