InfraWorks General Discussion

InfraWorks General Discussion

Reply
Valued Contributor
ScotBIM
Posts: 51
Registered: ‎08-22-2008
Message 1 of 2 (491 Views)

Importing Offset Alignments from Civil3D

491 Views, 1 Replies
12-15-2013 03:36 AM

We have been using Infraworks 2014 for the first time in ernest on a major housing development - however noticed early on that although Civil3d will create an IMX file of all the alignments, the ones that are "offset alignments" are not imported into Infraworks, or at least I can't see them.

 

When creating the IMX file in Civil3D it says that all the alignments have been exported.

*Expert Elite*
TRogers
Posts: 1,390
Registered: ‎09-05-2007
Message 2 of 2 (480 Views)

Re: Importing Offset Alignments from Civil3D

12-15-2013 08:29 AM in reply to: ScotBIM

InfraWorks roads are based off the centerlines.  If you were to have a centerline alignment and the offset alignments (edges of pvm't.), InfraWorks would see that as 3 roads.

If the issue was resolved by this method, please click on "Accept As Solution"
*Civil 3DJ*
Todd Rogers

Visit my blog here.

     
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.