The vertical elevation data is not exported with the alignment. To get the expected result, you may try to create a corridor with a top surface. It's important to have a surface to transfer your vertical profile.
Hope this helps,
Can you not just export a 3D polyline from the corridor "crown" and keep the elevations of that 3D polyline to represent the road C/L? I can't seem to use these 3D Polylines and generate roads, but I think there is a way to do that without generating a surface.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!