InfraWorks General Discussion

InfraWorks General Discussion

Reply
New Member
jnaven
Posts: 1
Registered: ‎02-09-2014
Message 1 of 2 (233 Views)
Accepted Solution

Create from Roadway design - Camera Path

233 Views, 1 Replies
02-24-2014 04:28 PM

Can an Offset be enter to the Create form Design Road Camera path - so you can drive down a Lane not the CenterLine?

No, unfortunately there is no such setting at the moment.

The only workaround I can think of is:

1. temporarily duplicate the road and offset it manually
2. create the camera path from this duplicate
3. remove the duplicate
Active Contributor
jutters
Posts: 42
Registered: ‎04-15-2013
Message 2 of 2 (217 Views)

Re: Create from Roadway design - Camera Path

02-25-2014 02:36 AM in reply to: jnaven
No, unfortunately there is no such setting at the moment.

The only workaround I can think of is:

1. temporarily duplicate the road and offset it manually
2. create the camera path from this duplicate
3. remove the duplicate
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.