InfraWorks General Discussion

InfraWorks General Discussion

New Member
Posts: 1
Registered: ‎02-09-2014
Message 1 of 2 (210 Views)
Accepted Solution

Create from Roadway design - Camera Path

210 Views, 1 Replies
02-24-2014 04:28 PM

Can an Offset be enter to the Create form Design Road Camera path - so you can drive down a Lane not the CenterLine?

Active Contributor
Posts: 42
Registered: ‎04-15-2013
Message 2 of 2 (194 Views)

Re: Create from Roadway design - Camera Path

02-25-2014 02:36 AM in reply to: jnaven
No, unfortunately there is no such setting at the moment.

The only workaround I can think of is:

1. temporarily duplicate the road and offset it manually
2. create the camera path from this duplicate
3. remove the duplicate
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.