InfraWorks General Discussion

InfraWorks General Discussion

Active Member
Posts: 9
Registered: ‎08-01-2007
Message 1 of 1 (381 Views)

Component of Infraworks 2014 R2 has stopped working

381 Views, 0 Replies
11-12-2013 08:55 AM

I am using corridors to bring my roadway design & materials into Infraworks and I discovered that I get the a Component of Infraworks has stopped working error when I check the box under Roads configuration --> IMX --> Use corridor regions instead of top surface. Once you click this box you will not be able to get back into your model.


Good luck.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.