InfraWorks General Discussion

InfraWorks General Discussion

Reply
Mentor
Robert_Fritz
Posts: 175
Registered: ‎12-08-2011
Message 1 of 2 (473 Views)
Accepted Solution

Aerial images not displayed

473 Views, 1 Replies
06-06-2012 03:15 AM

Hi,

 

I have created a project and added a dtm and some buildings. I then added georeferenced raster images ( one or multiple images - tried it several times) and configured them accordingly (Classification: aerial, Coordinate system: same as project). Images are processed but not displayed at all. If I turn off the surface still now images show up.

 

I then created a new project, just added the dtm and two raster files and then the files showed up. That's when I noticed that they are only displayed if i do not check the "clip to model extent" option. I then tried the same in my first project but to no avail.

 

basically - in one project the images show up, in the second one they don't. Both times it's the same data set.

 

Any ideas? I'm using 2013 on W7 64bit.

 

Many thanks,

Rob

http://raumpatrouille3d.blogspot.ch/

ok, figured it out while re-creating my project. The reason why the images were not displayed in one project was that i had themed  the surface and the theme overlayed the images and hence - nothing to see.

 

Mentor
Robert_Fritz
Posts: 175
Registered: ‎12-08-2011
Message 2 of 2 (471 Views)

Re: Aerial images not displayed

06-06-2012 04:40 AM in reply to: Robert_Fritz

ok, figured it out while re-creating my project. The reason why the images were not displayed in one project was that i had themed  the surface and the theme overlayed the images and hence - nothing to see.

 

http://raumpatrouille3d.blogspot.ch/
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.