Infrastructure Map Server General Discussion

Infrastructure Map Server General Discussion

Reply
Member
PascalFRANCOIS6037
Posts: 5
Registered: ‎09-17-2010
Message 1 of 2 (412 Views)

MGE 2011: Data Connection SHP / TAB on a remote server

412 Views, 1 Replies
07-05-2012 11:36 PM

Hello,

I want to make a data connection type SHP or tab to a remote server. To access the remote server, I tested the UNC address and the network drive common to all the organism.

MGE runs with local system account that was added to the LDAP group with the rights in full control on the remote server (only the data relevant directory).

For SHP, so I created a new alias in the serverconfig.ini then restart the service. In MapGuide Studio, when creating a new data connection SHP, I do not see the alias that I just created.

I tried the following recipe: create an alias as a shortcut to the existing remote server: the same result.

With the OGR provider, when I test the connection, I have the following error message:

An exception occurred in FDO component.
Connect failed:

Can you point to with MGE 2011 data on remote servers? If yes, what should I do?

Thank you in advance.

 

Bianca

Valued Mentor
jackie.ng
Posts: 284
Registered: ‎10-06-2008
Message 2 of 2 (401 Views)

Re: MGE 2011: Data Connection SHP / TAB on a remote server

07-08-2012 07:13 PM in reply to: PascalFRANCOIS6037

Is your alias pointing to a share (\\servername\share) or a folder inside the share (\\servername\share\foldername) ?

 

- Jackie

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.