Impression

Reply
Active Contributor
cadfuel
Posts: 38
Registered: ‎03-19-2004
Message 1 of 1 (64 Views)

Units in Impression

64 Views, 0 Replies
10-15-2008 02:15 PM
When you insert a drawing into Impression and are prompted for the drawing units, how is this going to affect your Impression design? What does this impact?

If you are normally an architectural firm for example and are sent a site plan from a civil firm, should you choose a scale of 1 unit = 1' as opposed to 1 unit = 1"?

I'm not sure I understand what will be affected by this.

Thanks!

Beth
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.