Impression

Impression

Reply
Member
cadman1966
Posts: 3
Registered: ‎07-21-2008
Message 1 of 5 (1,232 Views)

Program crash with Impression 2

1232 Views, 4 Replies
04-19-2010 04:17 AM
If I want to open each dwg file with impression 2 there every time the program crash. What can be the cause?

Please help me!
Valued Contributor
Jim_Earle
Posts: 62
Registered: ‎11-14-2007
Message 2 of 5 (1,140 Views)

Re: Program crash with Impression 2

08-11-2010 11:32 AM in reply to: cadman1966

seems like I remember a problem like this and the reason was not enough memory. Obviosuly if you have more than enoguh then its a differnt reason. If you can try it on another computer that would rule out a bad file. You may try re-installing impressions as well or give version 3 a shot.

Contributor
c.leitch
Posts: 14
Registered: ‎04-15-2009
Message 3 of 5 (895 Views)

Re: Program crash with Impression 2

01-26-2011 01:10 PM in reply to: Jim_Earle

Yikes, crashing on a system with 8gb ram here! Tried it on another with 12gb ram, same result. Trying version 3 now.

Valued Contributor
TexShalter
Posts: 80
Registered: ‎06-18-2010
Message 4 of 5 (858 Views)

Re: Program crash with Impression 2

02-03-2011 02:21 PM in reply to: c.leitch
Contributor
c.leitch
Posts: 14
Registered: ‎04-15-2009
Message 5 of 5 (856 Views)

Re: Program crash with Impression 2

02-03-2011 02:42 PM in reply to: cadman1966

Thank you so much, I had not seen the SP. FWIW working fine on version 3.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.