Impression

Reply
Member
cadman1966
Posts: 3
Registered: ‎07-21-2008
Message 1 of 5 (1,218 Views)

Program crash with Impression 2

1218 Views, 4 Replies
04-19-2010 04:17 AM
If I want to open each dwg file with impression 2 there every time the program crash. What can be the cause?

Please help me!
Valued Contributor
Jim_Earle
Posts: 62
Registered: ‎11-14-2007
Message 2 of 5 (1,126 Views)

Re: Program crash with Impression 2

08-11-2010 11:32 AM in reply to: cadman1966

seems like I remember a problem like this and the reason was not enough memory. Obviosuly if you have more than enoguh then its a differnt reason. If you can try it on another computer that would rule out a bad file. You may try re-installing impressions as well or give version 3 a shot.

Contributor
c.leitch
Posts: 14
Registered: ‎04-15-2009
Message 3 of 5 (881 Views)

Re: Program crash with Impression 2

01-26-2011 01:10 PM in reply to: Jim_Earle

Yikes, crashing on a system with 8gb ram here! Tried it on another with 12gb ram, same result. Trying version 3 now.

Valued Contributor
TexShalter
Posts: 77
Registered: ‎06-18-2010
Message 4 of 5 (844 Views)

Re: Program crash with Impression 2

02-03-2011 02:21 PM in reply to: c.leitch
Contributor
c.leitch
Posts: 14
Registered: ‎04-15-2009
Message 5 of 5 (842 Views)

Re: Program crash with Impression 2

02-03-2011 02:42 PM in reply to: cadman1966

Thank you so much, I had not seen the SP. FWIW working fine on version 3.

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.