Active Member
Posts: 6
Registered: ‎04-15-2003
Message 11 of 14 (181 Views)

Re: Memory Error

01-24-2007 05:58 PM in reply to: TerribleTim68
Ah, not supporting 64 bit. This explains failure to launch. I have 64 bit Windows XP Professional. You'd think the 'system requirements tester' would have picked that up.
Active Contributor
Posts: 26
Registered: ‎11-14-2006
Message 12 of 14 (181 Views)

Re: Memory Error

02-14-2007 02:43 PM in reply to: TerribleTim68
We just posted Impression Technology Preview 4 this morning:

This version has some improvements that should reduce the out of memory conditions.

We also save a recovery file if we need to close due to low memory conditions.
Active Member
Posts: 10
Registered: ‎12-05-2006
Message 13 of 14 (181 Views)

Re: Memory Error

03-05-2007 03:59 PM in reply to: TerribleTim68
Using 4, I get this message quite a bit, usually with fills, blocks and printing.
Active Contributor
Posts: 28
Registered: ‎09-27-2004
Message 14 of 14 (181 Views)

Re: Memory Error

03-08-2007 10:34 AM in reply to: TerribleTim68
using 4 and ran into this today also.
any tips on how to avoid this error?
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!