Impression (Read Only)
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Can't open a Beta file

1 REPLY 1
Reply
Message 1 of 2
Anonymous
1085 Views, 1 Reply

Can't open a Beta file

I have Beta tested Impressions 1 & 2, purchased release 1, updated to R2 and
now using R3 from the subscription site.

Today, I tried to open a file from January '07 in R3 and I get a message
that the file was created in a beta.....open and resave in in Impression R1
to convert it to a supported file format.

Is there any other way to open the file other than re-installing R1?
1 REPLY 1
Message 2 of 2
Anonymous
in reply to: Anonymous

I bit the bullet and reloading version1, saved the file and it now opens in
version 3. Quite the hassle, but it worked.
Mark

"MarkB" wrote in message
news:6226594@discussion.autodesk.com...
I have Beta tested Impressions 1 & 2, purchased release 1, updated to R2 and
now using R3 from the subscription site.

Today, I tried to open a file from January '07 in R3 and I get a message
that the file was created in a beta.....open and resave in in Impression R1
to convert it to a supported file format.

Is there any other way to open the file other than re-installing R1?

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report