Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I have a case where I have a set of holes (non-uniformed spacing) that is put in a weldment assembly using Sketch Driven Pattern. In the assembly where I am attaching the weldment I can't use the Sketch Driven Pattern to define a pattern for the hardware (bolts, washers, etc.). So I have to assemble six sets of hardware in these holes.
We are also encountering the same problem. Would it be possible to implement this into Inventor ? Below are two captures which I hope will make it easier to collect votes for this request.