Fusion Design, Validate & Document
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
Community
Fusion Design, Validate & Document
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

splitting a component

1 REPLY 1
Back to Fusion Category
Back to Topic Listing
Reply
Message 1 of 2
escmojo
Participant
862 Views, 1 Reply
‎04-14-2014 02:13 PM
‎04-14-2014 02:13 PM

splitting a component

Is it possible to sketch a line on a component and then split that component into two components along that line?

Report
0 Likes
Reply
1 REPLY 1
Message 2 of 2
innovatenate
Autodesk Support
in reply to: escmojo
‎04-14-2014 05:40 PM
‎04-14-2014 05:40 PM

The Modify > Split Body command should work for this. 

 

Thanks,

 

 




Nathan Chandler
Principal Specialist
Report
0 Likes
Reply
Reply

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report

Report a website issue