Community
Fusion Design, Validate & Document
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Sketch geometry is over constrained

6 REPLIES 6
Reply
Message 1 of 7
MrLoring
467 Views, 6 Replies

Sketch geometry is over constrained

When setting up construction lines get an over constrained error.  Some recommendations:

1.  Show me which constraints are causing the error.

2.  List possible solutions

6 REPLIES 6
Message 2 of 7
SallyYang
in reply to: MrLoring

Thanks for your feedback! We will consider your suggestions in future releases.

Hope to get more feedback from you again.

Regards,
Sally


Sally Yang
Software QA Engineer
Fusion 360 Quality Assurance Team
Autodesk, Inc.
Message 3 of 7
Helmi74
in reply to: SallyYang

This would be really helpful especially because the annoying bug that causes this error simply when ending a rectangle creation with enter instead of a mouse click is still there in the new version.
---
Frank / @helmi

Established 1974. Internet addicted since 1994. Collector of Kudos.
Message 4 of 7
gutenbar
in reply to: MrLoring

Is there any advance in this point?

It would be very nice to know which existent constraint is related to the action. It is a usability question.

Message 5 of 7
g-andresen
in reply to: gutenbar

Hi,

if you share an sample sketch and describe the problem area, something could be said about it.

 

günther

Message 6 of 7
gutenbar
in reply to: g-andresen

Hello Günther,

That was an isolated problem. It is normal I face restrictions caused by
constraints without information about what constraint is involved.

Generally, I locate it/them easily, but last weak I had a sketch where I
could move the lines freely using the mouse, but the program did not let me
specify a position using dimensions, even the wanted dimension been among
the values positioned with manually. Very strange.

I think that until today I saw only once, on the alert screen, indications
about what constraints were locking the drawing.

Thanks for the attention

Gutenberg
Message 7 of 7
TheCADWhisperer
in reply to: gutenbar


@gutenbar wrote:
Hello Günther,

That was an isolated problem.
…but the program did not let me
Very strange.
Thanks for the attention

Exactly the type of files that should be Attached here to get attention from the sketch solver team.

 

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report