Community
Perhaps I am missing something here, but isn't this what is expected? You are mirroring the body about a plane that is .25 cm away from the body, I would expect that the mirrored geometry should be .5 cm away from the original. What result do you expect to see in this case?
Thanks,
Jeff Strater (Fusion Development)
Jeff Strater
Engineering Director
Thanks,
Jeff Strater (Fusion Development)
Jeff Strater
Engineering Director
shame on me - what a logic fail.
Of course you are right.
However on a side note, it actually would be nice if you could mirror the part and with the plane define where the mirrored part should rest
somewhat like a mirror / array combo.
Of course you are right.
However on a side note, it actually would be nice if you could mirror the part and with the plane define where the mirrored part should rest
somewhat like a mirror / array combo.
Claas Kuhnen
Faculty Industrial Design – Wayne State Universit
Chair Interior Design – Wayne State University
Owner studioKuhnen – product : interface : design
Can't find what you're looking for? Ask the community or share your knowledge.
Post to forums
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")