Community
Fusion Design, Validate & Document
Stuck on a workflow? Have a tricky question about a Fusion (formerly Fusion 360) feature? Share your project, tips and tricks, ask questions, and get advice from the community.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Can't select Interference Tool's 'Keep' checkbox.

2 REPLIES 2
SOLVED
Reply
Message 1 of 3
donsmac
325 Views, 2 Replies

Can't select Interference Tool's 'Keep' checkbox.

Just tried Interference tool but the checkbox for keep doesn't select. Used a simple cube and cylinder.

I'm on a iMac 10.8.4

2 REPLIES 2
Message 2 of 3
AndrewSears
in reply to: donsmac

Can you supply a screen shot of what you see?

 

Thanks,

Andy 

Message 3 of 3
donsmac
in reply to: AndrewSears

There is a note that pops up if you stay hovered over check box. Says 'it's not supported in parametric. I did not see the note before cause I never left the mouse hovering over the check box long enough. Works fine if you are not in history mode. Also noticed it's not supported in base feature either. All good.

 

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report