Hardware

Reply
Contributor
SaintCrooner
Posts: 22
Registered: ‎03-30-2010
Message 1 of 2 (332 Views)
Accepted Solution

Worm Gear Assembly Cannot Open

332 Views, 1 Replies
02-27-2011 11:40 PM

 

Hello,

 

While working with Assemblies in Inventor 2011.A user is unable to open/view two parts of worm and a worm gear.

Only a worm is displayed.

 

The user can however see a worm and a worm gear under model browser.

 

What could be the problem and how can this be fixed.I have so far tried repairing the installation without uninstalling the software.

 

NB:

The user follows this path to open the above mentioned.

 

New-Design-Spur Gears-Worm Gears and accepts the default settings.

Spur and Bevel Gears open their assemblies without a problem.

 

Kindly assist.

 

Regards,

Peter K'onunda,

Nairobi,Kenya.

I found a fix for the problem,....

The computer was also developing some problems, so we formatted and did a new installation.

Evereything now works fine.

 

Contributor
SaintCrooner
Posts: 22
Registered: ‎03-30-2010
Message 2 of 2 (310 Views)

Re: Worm Gear Assembly Cannot Open

03-03-2011 11:31 PM in reply to: SaintCrooner

I found a fix for the problem,....

The computer was also developing some problems, so we formatted and did a new installation.

Evereything now works fine.

 

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.