Announcements
Visit Fusion 360 Feedback Hub, the great way to connect to our Product, UX, and Research teams. See you there!
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Measure enhancement - midpoints

Measure enhancement - midpoints

I would like the measure command to be able to find the mid point of any entity. In the attached image, I want to know what the distance of the part is from the base to the quadrant point of the arc. Right now when you select the base and the arc, it gives you the length to the center of the arc.

 

Screen Shot 2015-01-25 at 8.40.43 PM.png

3 Comments
omartan90
Enthusiast

Not only midpoints but also center points for circles and broken circles, also the snapping should work in the Move tool as well. Right now let say I want to align a face to the center of a hole, there's no way to do that cause it'll snap to the edge of the hole unless I measure before hand the distance. 

schneik-adsk
Community Manager
Status changed to: オートデスク今後検討
 
promm
Alumni
Status changed to: Implemented

@kellings,

 

The new measure enhancements have provided a solution to your idea.  In the video below I show the tip where holding down command "Mac" or control "PC" will allow the face selection to stay active when picking points

 

http://autode.sk/1qKdIZG

 

Regards,

 

Mike Prom

Can't find what you're looking for? Ask the community or share your knowledge.

Submit Idea  

Autodesk Design & Make Report