Freewheel

Reply
Contributor
wagi2
Posts: 24
Registered: ‎09-16-2003
Message 1 of 2 (194 Views)

DWF are not visible in Freewheel

194 Views, 1 Replies
05-15-2007 12:29 PM
Hi!

my "Spongebob" modelled in Inventor 11 and published with Inventor 2008 is not visible after opening it in freewheel. In Design Review the DWF files works fine.
here is the File
http://blog.inventor-faq.de/dateien/spongebob.dwf

Thankyou for your help!

Juergen
*Scott Sheppard - Autodesk
Message 2 of 2 (194 Views)

Re: DWF are not visible in Freewheel

05-16-2007 05:07 AM in reply to: wagi2
Thanks for mentioning this. Project Freewheel (http://dwfit.com) mentions
this:

Password protected, and DRM (measure-disabled and print-disabled) DWF files
are not currently supported.

This was inadvertently left off of Autodesk Freewheel
(http://freewheel.autodesk.com). I will pass this on to the marketing team.

wrote in message news:5586903@discussion.autodesk.com...
Hi!

my "Spongebob" modelled in Inventor 11 and published with Inventor 2008 is
not visible after opening it in freewheel. In Design Review the DWF files
works fine.
here is the File
http://blog.inventor-faq.de/dateien/spongebob.dwf

Thankyou for your help!

Juergen
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.