Freewheel

Reply
Active Member
tilehaus
Posts: 8
Registered: ‎05-13-2007
Message 1 of 4 (299 Views)

Background color

299 Views, 3 Replies
05-02-2009 06:49 AM
The background color of my DWF file does not show up on the Freewheel display nor does it appear on the rendered thumnail preview images. Is there a parameter that can set this background color to something other than white?
*Scott Sheppard - Autodesk
Message 2 of 4 (299 Views)

Re: Background color

05-04-2009 06:57 AM in reply to: tilehaus

1. I hope the background color is as it was
published in the DWF. If not, please send your file to
href="mailto:labs.freewheel@autodesk.com">labs.freewheel@autodesk.com
and we
can take a look at it. we will treat your data confidentially.


 


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
The
background color of my DWF file does not show up on the Freewheel display nor
does it appear on the rendered thumnail preview images. Is there a parameter
that can set this background color to something other than
white?
Active Member
tilehaus
Posts: 8
Registered: ‎05-13-2007
Message 3 of 4 (299 Views)

Re: Background color

05-06-2009 07:24 PM in reply to: tilehaus
Thanks for directing me to the additional parameters - unfortunately the '&bg= parameter does not change the background color using the rendering service (dwfimage.aspx) - it remains white. I also tried the '&bg=' parameter on the interactive viewer with no effect. I will send you the image I started with and a link to my demo page.

I also would like to use the embedded viewer on my webpage, and trigger the dwf displayed in the viewer from a link on a rendered image on the same page. Is there any way to pass commands to the embedded viewer that would change section displayed like the '&sec=' does?
*Scott Sheppard - Autodesk
Message 4 of 4 (299 Views)

Re: Background color

05-09-2009 06:07 AM in reply to: tilehaus

The &bg parameter only applies to 2D and not
3D. We can consider this for a future update.


style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
Thanks
for directing me to the additional parameters - unfortunately the
'&bg= parameter does not change the background color using the
rendering service (dwfimage.aspx) - it remains white. I also tried the
'&bg=' parameter on the interactive viewer with no effect. I will send you
the image I started with and a link to my demo page. I also would like to use
the embedded viewer on my webpage, and trigger the dwf displayed in the viewer
from a link on a rendered image on the same page. Is there any way to pass
commands to the embedded viewer that would change section displayed like the
'&sec=' does?
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.