Community Search
Didn't find what you're looking for?
Ask the community.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
7 results
Sorted by:
Is it possible to get the von Mises stress scale in the results to be a specific colour for a specific stress. I am trying to show the stress difference between two versions of a component, the stres...
I'm largely self taught on this software so sometimes I run into problems I think should be easy, but I have a hard time with. Please help! How can I get loading on a bonded face joint to ca...
Problem: When someone else opens my assembly the content center parts are not found. This presents the open/find a part dialogue box just like if I had moved or deleted the files.
...
So I wanted to detail something with a sketch (it is a decal and not in my model). However I cannot figure out how to have my dimensional scale of my sketch match my scale of a model with a sketch. ...
Can anyone give me a run down of the FEA differences between Inventor Ultimate versus the most basic package of Simulation: limitations, analysis types, cost, system requirements, etc? ...
I have a fillet that is not showing up on my IDW (on the top of the slot shown below). I have hidden lines included in the view. Did not help. I need to have the fillet noted in the drawing, so I hav...
Is there an easy way to measure percent (nodes or volume) of a model that is over over/under a number (tensile yield for example)? In my project requirements no more than 10% of an FEA model may...