Community Search
Didn't find what you're looking for?
Ask the community.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
1 result
Sorted by:
Hello, I have a trial verzion of Inventor 2012 and doing a little evaluation project which requires a square hole and also a round screw hole both in a radiused surface. The first, I can not find an...
Show results in replies (5)
-
In Reference to #2. Where is this aligned solution in the insert solution? I am new at this being ...
-
But I am trying to place a hole in a part that has a curved surface and I am not in the assembly en...
-
I meant to say where is this insert restraint?
-
I hope I did this right with the attachment below. As you can see the round hole in the piece at th...
-
Sketch 1 is not constrained or making use of obvious symmetry about the origin. Sketch2 and 3 look...