Community Search
Didn't find what you're looking for?
Ask the community.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
5 results
Sorted by:
Hello, I have run into something new that has caused me to loose what little hair I have left. I am drawing what essentially looks like a wing rib and after getting the basic shape I found out that ...
Hello, Sorry to ask what is probably a daft question but I am having trouble creating a flat pattern from a rolled part. I know I have done this in the past but for the life of me I cant think what I...
- Tags:
- Flat pattern
- unfold
I am having trouble with ripping a lofted cone that I am sure I have done in the past. The part is a simple cone that will be part of a fabrication. I want to rip it on an angle to make it easier to ...
I have created some curved straightening vanes to go inside a large square duct 90 degree elbow. Each vane starts with a 6" long straight section the its follows a fixed radius through 90 degrees. Wh...
Hello, I am having trouble unfolding a curved part. I drew five parts of similar design in varying sizes. The first three unfold perfectly and export to dxf. The last two do not unfold, when I toggl...