Community Search
Didn't find what you're looking for?
Ask the community.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
3 results
Sorted by:
02-04-2013
12:36 AM
Hello. Just by selecting a bend line on the flat pattern, I'd like to draw only 2 lines on a sketch (without any border projection, only points) at both ends of the bend line. I'm sure it ca...
I have modified the diameter of the holes of a a derived part using the direct modeling tool: When it went for laser cutting, I have been noticed that the diameter o...
12-13-2012
07:57 AM
Hello, Is there a way to have a lowercase revision number in a drawing (in fact, it's not really a number but a character). All I can set is uppercase format or numbers.