Community Search
Didn't find what you're looking for?
Ask the community.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
831 results
Sorted by:
I build a simple 3D cantilever beam model (Long: 200mm, Width:40mm, Thick:2mm) by CAD software, then import into Algor. The beam is fixed at one end. Uniform surface pressure( 0.025N/mm^2 ) is set to...
Good evening, I have a problem with the schematic of a cylindrical roller bearing. I created a joint mesh on the surfaces of the crankshaft where the bearings are applied and can not understand whe...
Hello , In the attached pipe i tryed to run a flow analysis wich is based on the gravity force . If the fluid is Air or Water i get the same message : **** The solution did not meet convergence crite...
Hello, I am having a cylindrical part which is filled with a fluid, and rotates. To avoid having to do several models of the same thing and changing them in CAD, I was thinking of doing one ...
Hello, I am having some problem getting two surfaces that should bond to do just that. This is a problem where I have to mix solids and shell elements, so what I have done is basically to cr...
Hello, I am trying to generate fluid mesh within an inclosed tube for multi-physics fluid flow and thermal. The inner surface of the tube consists of multiple surfaces (~20) despit...
As the title says, I was wondering if there's a possibility to visualize the LPF (Load Proportionality Factor) or Load Level in Algor? It would be a handy tool, I think. I haven't found anything in t...
Does Algor have a manual available? Check out Solid Works Flow - a beautiful 250 page colour manual with Tutorials. Very Nice! A good product needs good support, yes?
Hi, I made a static stress analysis and a fatigue analysis. When the fatigue analysis is finished, I don't have the fatigue results in the results menu. Do you have a solution...
Hello, I have a Chuck assembly attached as a jpeg file here. It is a very simple assembly where a Spindle Plate is bolted to an Adapter plate and Adapter plate is bolted to the Chuck. I have...