FMDesktop

Reply
New Member
krasnykh
Posts: 2
Registered: ‎07-12-2010
Message 1 of 2 (1,714 Views)

PLine issue, acad config

1714 Views, 1 Replies
07-12-2010 11:07 AM

I have an array of points (xi,yi) which were created another then ACAD software. The format of array is as follows (for example):

5.1,3.2

5.4, 4.3

….

28.1,-8.3

I would like to create PLINE according to this array. In earlier ACAD  version there was not a problem to do that. I selected the array and copied into the PC memory (Ctrl_C of selected array). After that I typed command PLINE (or pick up this option) and pasted the data (Ctrl_V). ACAD creates the needed line. I have a problem to do that in ACAD 2009. The software pastes the array itself instead of the line. Is it possible to configure ACAD like it was in the earlier version? Thank you.

New Member
krasnykh
Posts: 2
Registered: ‎07-12-2010
Message 2 of 2 (1,713 Views)

Re: PLine issue, acad config

07-12-2010 12:00 PM in reply to: krasnykh

I found a solution myself.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!