Factory Design Suite General Discussion

Factory Design Suite General Discussion

Posts: 237
Registered: ‎06-13-2011
Message 1 of 2 (70 Views)

unhandled exception

70 Views, 1 Replies
10-11-2012 03:09 AM

When i place my first panel with ilogic and i change one measure in the 'Place ilogic Component' view i get an error.

Then i click continue and i can change the second measure and again a get the same error.

After changed both measures nothing happens.

The panel will not be placed.

When i don't change anny measure the panel will be placed.


Mvg Jos

Your drawings are only as good as the symbols that complete them...
Posts: 437
Registered: ‎03-15-2009
Message 2 of 2 (65 Views)

Re: unhandled exception

10-11-2012 06:38 PM in reply to: j.vanderheijden

Hi Jos,


I didn't get any error when I palce the part with iLogic by Place iLogic Component command and change the measure.So can you help attach the video of your workflow.




Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.