Factory Design Suite General Discussion

Factory Design Suite General Discussion

Posts: 4
Registered: ‎08-13-2008
Message 1 of 2 (131 Views)

Templates Publishing Assets and sync to Inventor

131 Views, 1 Replies
12-12-2012 11:16 PM



I get the following warning:


"The template file you are using to create the new document needs to be migrated. Please open it and explicitly save it before using it to create any documents"


This warning occurs both when I'm publishing asset (during 2D representation generation) and synchronization of a structural, mechanical dwgs. (although the architectural dwg I created, started from a 2004 autocad dwg)


I already have tried to update as many templates as I could find, but it still doesn't work. Can you tell me which one I have to migrate?


Kind Regards



Posts: 437
Registered: ‎03-15-2009
Message 2 of 2 (122 Views)

Re: Templates Publishing Assets and sync to Inventor

12-13-2012 09:30 PM in reply to: peter1986

Hi Peter,


Please give a try to migrate the following dwg template that in Inventor.

C:\Users\Public\Documents\Autodesk\Inventor 2013\Templates\Metric\ANSI (mm).dwg

C:\Users\Public\Documents\Autodesk\Inventor 2013\Templates\English\ANSI (in).dwg




Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.