Factory Design Suite General Discussion

Factory Design Suite General Discussion

New Member
Posts: 5
Registered: ‎08-30-2012
Message 1 of 2 (156 Views)

Changing Asset Properties in ACADA or ACADM

156 Views, 1 Replies
08-30-2012 07:48 AM

Hello there!


Is it possible in FDSU 2013 to change the Properties of an asset like an Conveyor?

I want to change the width of such a conveyor - but I only see the way in synchronizing to Inventor and then to change the width there? Is there a way to change it in the 2d-Layout?


Thanks for your answers



Posts: 339
Registered: ‎07-29-2008
Message 2 of 2 (150 Views)

Re: Changing Asset Properties in ACADA or ACADM

08-30-2012 08:01 AM in reply to: Frank.Schmelzer

Hi Frank -


The only way that you can change parameter values for assets placed in AutoCAD is to use variants -- these are predefined (at asset publish time) sets of parameter values, for which the system automatically generates corresponding DWG blocks for use in AutoCAD.


Only in Inventor can you modify parameter values individually.



Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.