Factory Design Suite General Discussion

Factory Design Suite General Discussion

Reply
*Expert Elite*
Dan.M
Posts: 605
Registered: ‎01-19-2009
Message 1 of 2 (77 Views)

Cable and harness between assets

77 Views, 1 Replies
12-29-2012 11:12 AM

Hi

I get an error when I try to build a wire or cable between two points. 

If i try to pass a segment everything is fine. 

Someone saw this before? 

 

Thanks

Dan

Employee
XuesongBai
Posts: 437
Registered: ‎03-15-2009
Message 2 of 2 (64 Views)

Re: Cable and harness between assets

12-30-2012 07:30 PM in reply to: Dan.M

Hi Dan,

 

I didn't see the error as you. Is it related to the specific data set? If possible, can you share the data with me by Xuesong.bai@autodesk.com.

 

 

Thanks,

-Xuesong

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.