Fabrication CADmep
Join the Autodesk Fabrication CADmep community discussions to help share and receive technical product knowledge, insight, tips and tricks.

Fabrication CADmep

Reply
Contributor
bparrell
Posts: 25
Registered: ‎11-07-2006
Message 1 of 2 (279 Views)

Trimble export through Dynamic blocks

279 Views, 1 Replies
08-30-2013 08:50 AM

Alot of roof supports have to be created differently than the Itms presently via a dynamic block.When creating these it is easy to attach trimble points to the base plates,but the export you need to xplode the block which is no good if your using a dataextraction(dxe)inorder to build the actual support.

Contributor
bparrell
Posts: 25
Registered: ‎11-07-2006
Message 2 of 2 (263 Views)

Re: Trimble export through Dynamic blocks

08-30-2013 10:02 AM in reply to: bparrell

Please repost to the new idea area.My bad

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.